Home > Woodturning > Pen Turning Supplies > Pen Assembly & Disassembly > 7mm Pen Disassembler Tool

7mm Pen Disassembler Tool

Item #: PKDISPEN
$12.95
Quantity:
In Stock Ready to Ship
Add to Wishlist
View Instructions
View in Catalog

Rating 5 out of 55 out of 55 out of 55 out of 55 out of 5

Description Specifications Shipping Reviews and Awards
7mm Pen Disassembler Tool
For 7 mm Slimline & Comfort Pens.
Use these tools to remove pressed on parts from assembled pens. Salvages parts and allows refinishing barrels.
Category: Pen Assembly & Disassembly
  • Package Weight: 0.22 pounds
  • Subject to Minimum $7.50 shipping charge
  • Packing: This item may pack with other items.

Note: Above shipping policies apply to Continental US only. We will call or email to advise you of shipping policies to other locations.

Average Customer Review: 5 out of 55 out of 55 out of 55 out of 55 out of 5 15 Reviews

Write an online review and share your thoughts with others.

5 out of 55 out of 55 out of 55 out of 55 out of 5 Nice tool
Reviewer: John Czohla (Lafayette, NJ)
Submitted: 11.10.2009

Saved my mistakes, great tool , couldn't be without.

5 out of 55 out of 55 out of 55 out of 55 out of 5 Good Tool
Reviewer: Daniel Hart (Independence, KY)
Submitted: 9.29.2009

This tool saved me a few pens.

5 out of 55 out of 55 out of 55 out of 55 out of 5 Worked Great
Reviewer: James Cochrun (Ewa Beach, HI)
Submitted: 7.14.2009

The disassembler tool worked great. Was easy to use. The directions were very simple and easy to follow. Had no problems and shipping was very fast.

5 out of 55 out of 55 out of 55 out of 55 out of 5 Helpful
Reviewer: Lyle Majeska (La Puente, CA)
Submitted: 6.30.2009

Works well - easy to use.

4 out of 54 out of 54 out of 54 out of 54 out of 5 Pretty good but not perfect
Reviewer: C. H. (, IA)
Submitted: 6.24.2009

Well, for the cost I would say it's worth it. However, it can get misshapen from pounding on it with the hammer. So I use the same end of the rod all the time so I won't mess up both ends. Also, once I had a piece get stuck in the twist mechanism receiver and not thinking, I pounded on the receiver to loosen it. Then I had a terrible time getting it back in shape so the rod would slide properly again. But, all in all, it's a very helpful tool. Just remember to work over a little container of some kind to catch the parts as they fly off.

View all 15 reviews

LEARNING CENTER

Online prices and selection generally match our online catalog, but may vary.
Prices and offers are subject to change.
© Penn State Industries
All Rights Reserved.