Home > Woodturning > Lathe Accessories > Lathe Tool Rests > 3 Piece Tool Rest Set for Full Size Lathes: 1" dia. Post

3 Piece Tool Rest Set for Full Size Lathes: 1" dia. Post

Item #: CLTSET1
$29.95
Eta Late December / Join the waitlist to be emailed when it's in stock
Shipping Charge: $9 shipping for ground service
Add to Wishlist
View in Catalog

Rating 4 out of 54 out of 54 out of 54 out of 54 out of 5

Description Specifications Shipping Reviews and Awards

3 piece Tool Rest set for Full Size Lathes - 1" post

These heavy duty Tool Rests provide you with vibration free turning. The set includes: two radius Tool Rests for inside hollowing and exterior wood removal. They also enable you to position your chisels close to the work to eliminate vibration while turning. Suitable for bowls from 10" dia inside to 16" outside.

Set Includes 3 Tool Rests:

•5" radius with 1-1/4" x 3/16" thick bar
•8" radius with 1-1/4" x 3/8" thick bar
•12" straight with 3/4" diameter bar
•Tool Rest post: 1" dia 5-3/4" long
Category: Lathe Tool Rests
  • Package Weight: 8.25 pounds
  • Shipping Charge: $9 shipping for ground service
  • Packing: Item is shipped in its own box.

Note: Above shipping policies apply to Continental US only. We will call or email to advise you of shipping policies to other locations.

Average Customer Review: 4 out of 54 out of 54 out of 54 out of 54 out of 5 3 Reviews

Write an online review and share your thoughts with others.

4 out of 54 out of 54 out of 54 out of 54 out of 5 very handy
Reviewer: Tony Fredericks (Hayward, CA)
Submitted: 9.6.2009

While the workmanship on them isn't so great, they really come in handy for small bowl work, and I think they're a good deal.

1 out of 51 out of 51 out of 51 out of 51 out of 5 Total Junk
Reviewer: Herbert Gellner (Clinton, MD)
Submitted: 8.11.2009

I got these a few days ago, and I'm shocked at the quality of junk they're sending out. The steel looks like it was cut with a brick. Rough, sharp edges, uneven steel width, tool posts ground down like something out of a 1840's blacksmith shop. The welds are terrible. It'd be a miracle if it even held together long enough to actually use. I have to grind the edges straight, have the posts re-welded, and wire brush the rust off them, just to make them usable. Too bad there's no rating lower than 1 star, because it doesn't even deserve that much. Save your money & buy these elsewhere. These are total junk.

5 out of 55 out of 55 out of 55 out of 55 out of 5 What a deal...
Reviewer: Don Carter (Tupelo, MS)
Submitted: 1.24.2009

I shouldn't be telling PSI what a deal this set of tool rests is! I have been using them now for about a month and I am very pleased. The curved rest allow much better bowl turning. The straight "T" is very sturdy and my crossbar measured 1" in diameter even though the description here says 3/4". These are quality tool rests.

LEARNING CENTER

Online prices and selection generally match our online catalog, but may vary.
Prices and offers are subject to change.
© Penn State Industries
All Rights Reserved.